ROUND Pools Ambassador Manuel d'utilisateur télécharger pdf (Page 10)

ALTERNATE STEP 4 -

PRE-ASSEMBLING THE STRAIGHT SIDES OF A BUTTRESS-FREE OVAL POOL ONLY:

*** IF YOU HAVE A TRADITIONAL BUTTRESS OVAL PLEASE REFER TO THE PREVIOUS STEP 4!

A) Start by laying out the under box channels so that the open

sides of each under box channel is facing up. Then slide the

strap end channel over the top of the under box channels so

that they form a tube. Be sure that the holes in both channels

are aligned, but do not bolt them together yet. See Fig. 11

B) Now slide the straight side 4"x4" uprights over the strap

end channels making sure that the holes line up as

shown in Fig.12.

C) Once the straight side 4"x4" uprights are attached, apply the

left and right side gussets on each. The pieces are marked

"L" and "R". The gussets are applied under the channels and

around the straight side upright. Once you have them in

place screw the left and right gussets to each other using

three #10 screws. See Fig.13 for visual instructions.

D) All holes should be lined up at this point. Bolt the components

together as shown in the diagram. Use 5/16" x 5" long bolts

and 5/16" nuts for the channels, and 5/16" x 4 ½" long

stainless steel bolts for connecting the gussets to the uprights.

Remember to include the three-hole washer at the fronts of

the gussets. If these washers are left off your pool will break!

See Fig.14 for visual instructions.

E) Once all of the 5" long bolts have been tightened, install the

straight side bottom connectors. This is done by placing the

connector on top of the strap end channel just inside the

straight side upright. The hole in the connector should line

up with the hole in the strap end channel. Secure the

connector to the channel using a single # 12 x ¾" screw

for each as shown in Fig.15.

4 1/2" long

ss bolts

5" long bolts

PART IDENTIFIER

*Please do not be alarmed if you are not using all of the holes in the strap end channels. We use this same

channel for a few different products so there are some holes that you will not be using for this pool. You will

also have 3 extra 5/16" x 4 1/2" stainless steel bolts per upright when installing the Butress-Free system.

Please follow diagrams to be sure you are using all of the correct holes and hardware.

Fig. 11

Fig. 12

Fig. 13

Fig. 14

Fig. 15

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

ROUND Pools Ambassador Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Piscines hors sol ROUND Pools Ambassador