ROUND Pools Ambassador Spécifications télécharger pdf (Page 29)

7" XL TWO-PIECE WRAP AROUND COVER AND PEDESTAL

1 - Insert the logo into the cover.

2 - Slide the outside cover into position and align the hole in the cover with the cage

nut attached to the top plate. Secure using the 1/4”-20 x 3/4” screw provided.

3 - Insert the front of the top cover into the hole in the front of the outside cover.

Pull the back of the top cover down until it securely fits under the inside lip

of the ledge. Make sure the bottom lip on the back of the top cover goes

over the back edge of the ledge (Fig. 4).

4 - Align the holes on the side of the bottom wrap with the holes on the top of

the vertical. If the holes are not there or the cover does not reach the holes

simply drill a new set of holes into the vertical.

Secure the cover using the #12 x 1/2” screws provided.

7” XL WRAP

1/4”-20 X 3/4”

AROUND

STAINLESS STEEL

COVER

LOGO

TOP

COVER

WRAP AROUND PEDESTAL

1 - Insert the logo into the pedestal.

2 - Place the pedestal onto the bottom of the vertical

and align the holes on the side of the wrap with

the holes on the bottom of the vertical.

3 - Secure the pedestal using the #12 x 1/2” screws provided.

SCREW

#12X1/2” SCREW

1 ON EACH SIDE

OUTSIDE

COVER

IMPORTANT:

Make sure that the

inside edge of the

top cover is securely

positioned over the

edge of the ledges

#12X1/2”

SCREW

1 ON EACH

SIDE

If your pool vertical

does not have holes,

simply use the cover

or the pedestal as

a template and drill

through the vertical

using a 9/64" diameter

drill bit, being careful

not to damage

the pool wall.

1 2 ... 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire

ROUND Pools Ambassador Spécifications Page 29

Commentaires sur ces manuels

Produits connexes et manuels pour Piscines hors sol ROUND Pools Ambassador